Set protocols ospf passive-interface-exclude ‘wg01’ Set policy route-map CONNECT rule 10 match interface ‘wg01’ Set policy route-map CONNECT rule 10 action ‘permit’ Set interfaces wireguard wg01 port ‘51820’ Set interfaces wireguard wg01 peer to-wg02 pubkey ‘xxxxxxxxxxxxxxxxxxxxxxx=’ Set interfaces wireguard wg01 peer to-wg02 allowed-ips ‘10.1.0.0/30’ Set interfaces wireguard wg01 peer to-wg02 allowed-ips ‘192.168.5.0/24’ Set interfaces wireguard wg01 ip ospf transmit-delay ‘1’ Set interfaces wireguard wg01 ip ospf retransmit-interval ‘5’ Set interfaces wireguard wg01 ip ospf priority ‘0’ Set interfaces wireguard wg01 ip ospf network ‘point-to-point’ Set interfaces wireguard wg01 ip ospf hello-interval ‘2’ Set interfaces wireguard wg01 ip ospf dead-interval ‘6’ Set interfaces wireguard wg01 ip ospf cost ‘10’ ![]() Set interfaces wireguard wg01 ip ospf bfd Set interfaces wireguard wg01 ip ospf authentication plaintext-password ‘ospf’ Set interfaces wireguard wg01 description ‘VPN-to-wg02’ Set interfaces wireguard wg01 address ‘10.1.0.1/30’ Please check the configuration and point me to the error: It did not help establish the neighborhood. ![]() I tried the point -to-point network option and tried the broadcast network option. On VyOS, no firewall rule is bound to the wireguard interface. On Mikrotik, all traffic through the Wireguard interface is completely open. And neighborly relations are not established. But it does not receive Hello in response. I have successfully established a connection through wireguard. The task is to connect another Mikrotik there. I have a VyOS which is receiving multiple tunnels.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |